DIY Case for raspberry pi2 <1$

[prash2k01]

I was looking for my pi2 case and after reading .....reading and reading over internet than decided to go for DIY

Cost is just 50 India n rupees
--20 rupees for hard plates from electrical store who prepare switch boards of wooden plates in old style
--30 rupees for nut bolt from a hardware store .... Longer than normal one

Process can be understood through pictures below [emoji4]





View attachment 19375

View attachment 19376

 

[gcr]

Thats good.
Did you measured temperature? Place the bottom plate bit more lower. It will help in decreasing the temp. Also get a cover for bolt, like radio antenna or some plastic refill lying unused. Try acrylic pieces . That will make it more appealing..

 

[prash2k01]

Thats good.
Did you measured temperature? Place the bottom plate bit more lower. It will help in decreasing the temp.

nope i did not check the temp.....but we can add more no of nuts to get it lower.

yeah we can make it more beautiful with some alterations

 

[gcr]

nope i did not check the temp.....but we can add more no of nuts to get it lower.

yeah we can make it more beautiful with some alterations

This is mine
http://1drv.ms/1Wqo2nu
http://1drv.ms/1Wqo2Uo

IMHO the nuts between rpi is not needed. It will hold to the bolts strongly.

 

[prash2k01]

This is mine
http://1drv.ms/1Wqo2nu
http://1drv.ms/1Wqo2Uo

IMHO the nuts between rpi is not needed. It will hold to the bolts strongly.

i saw ur's in rpi thread and was planning to build like that but found mine easy and cheap solution .... but your's look awesome

extra nuts for making more space only