There is already my thread on this amplifier but this time i am improving it hence i am starting a new thread. As a First Post of this thread i will add some Photos of my new DIY enclosure ( A little Teaser )
Enclosure Dimensions (Complete Aluminum)
Outside : 515 mm Width x 308 mm Deep x 240 mm Height
Inside : 350 mm Width x 290 mm Deep x 234 mm Height
Face Plate Dimension : 515 mm Width x 250 mm Height x 12 mm thick
Photo of a bottom plate 4 mm thick aluminum, cut on laser cnc except the drill holes.
Top plate 2 mm thick aluminum, cut on laser cnc except the drill holes.
Semi assembled top and bottom plate with heat sinks.
Back plate 6 mm thick aluminum, cut on laser cnc except the drill holes.
Face plate 12 mm thick aluminum, machined on manual milling.
Complete rough assembly
The Gap which is seen between the face plate and rest enclosure will not be there once the screws are fitted in the middle of face plate.
Finishing is yet to be done. This Enclosure had made a big hole on my pocket and the Power bank has made it even wider...... lol
More is yet to come as the progress goes on.
Sadik
Enclosure Dimensions (Complete Aluminum)
Outside : 515 mm Width x 308 mm Deep x 240 mm Height
Inside : 350 mm Width x 290 mm Deep x 234 mm Height
Face Plate Dimension : 515 mm Width x 250 mm Height x 12 mm thick
Photo of a bottom plate 4 mm thick aluminum, cut on laser cnc except the drill holes.
Top plate 2 mm thick aluminum, cut on laser cnc except the drill holes.
Semi assembled top and bottom plate with heat sinks.
Back plate 6 mm thick aluminum, cut on laser cnc except the drill holes.
Face plate 12 mm thick aluminum, machined on manual milling.
Complete rough assembly
The Gap which is seen between the face plate and rest enclosure will not be there once the screws are fitted in the middle of face plate.
Finishing is yet to be done. This Enclosure had made a big hole on my pocket and the Power bank has made it even wider...... lol
More is yet to come as the progress goes on.
Sadik