Lm4780 PCB Layout help

[saheb11123]

Hi everyone,

This is my first build of a chipamp/ or any good quality amp at that. After waiting and deciding for a long time, i have picked up the components needed and pcb's as well for the build of LM4780. I don't know which design this follows because this has been purely suggested by one FM.

Cranky, a great guy, a very great guy, he has been my mentor and my GK for the time when I first stepped into this world.

As cranky suggested and listed I have gathered all the components, took help of a good FM, koushik (da) , also a great guy, now I'm stuck at a point,

i have attached three picture of the pcb and one pdf of the layout, but I can't figure out which goes where.

Cranky has promised to help me but not before next week.
Frankly, I cant sit down now when i have all the components and don't know how to fit them.

I have also finished the Power supply.(which is working well )

So i requesting and begging all experienced FM to help me out please.
:sos::sos:
Thanks and regards

:signthankspin:
saheb11123
Soumyajyoti

 

[saheb11123]

Anyone bump!!

 

[omishra]

There must be schematic for the PCB layout. Without that tracing and marking will take more effort.
You have to start marking component side of PCB by looking at schematic.

 

[saheb11123]

I found out , sangram da aka cranky just informed me, that the pcb is non-working. So back to square one.

Does somebody have any spare lm4780 or lm3886 pcb that they can sell to me.?