Open Baffle with Vintage Philips Driver

[mksharan]

I recently picked up couple of Philips Drivers(6" dia) used for radio in the flea market in Geneva. These were made in Belgium, sometime in 70's and were in very good condition.

I had a old board of 14 by 22 inches and mounted the driver as Open Baffle. This is my first prototype and the drivers are mounted in corner, based on results of simulations using EDGE(Home of the Edge)

Will later mount a tweeter and connect it to a woofer mounted in H frame (as described in post by Bhaskarcan (http://www.hifivision.com/diy/45591-my-diy-open-baffle-speakers.html). Hope to complete the H frame this week-end.

The setup and initial measurement is attached.

I request the advise and response from experienced DIY enthusiasts for taking this project forward.
Thanks
Manoj

 

[sgmane]

I recently picked up couple of Philips Drivers(6" dia) used for radio in the flea market in Geneva. These were made in Belgium, sometime in 70's and were in very good condition.

I had a old board of 14 by 22 inches and mounted the driver as Open Baffle. This is my first prototype and the drivers are mounted in corner, based on results of simulations using E..

Manoj - Congrats on your new project. Well i am no DIY guy myself, but appreciate your efforts in getting into. Keep posting us the latest updates on your project. Look forward to see you complete setup.