DENON AVR 1713 with JBL SCS 138

[jitzpop]

Hello everyone,

I am very new to this forum and getting to know more about being an audiophile. I need a help with my setup. I recently purchased a DENON AVR 1713 but not yet invested in any speakers. I was thinking to reuse my JBL SCS 138 setup that I was using with my older AVR. I wanted to know if these speakers would be good for the new AVR. If not what would I be missing out on.

Thanks in advance for your help.

Following are the specifications for DENON AVR 1713:
Power amplifier
Front:
80 W + 80 W (8 ?, 20 Hz 20 kHz with 0.08 % T.H.D.)
120 W + 120 W (6 ?, 1 kHz with 0.7 % T.H.D.)
Center:
80 W (8 ?, 20 Hz 20 kHz with 0.08 % T.H.D.)
120 W (6 ?, 1 kHz with 0.7 % T.H.D.)
Surround:
80 W + 80 W (8 ?, 20 Hz 20 kHz with 0.08 % T.H.D.)
120 W + 120 W (6 ?, 1 kHz with 0.7 % T.H.D.)
Output connectors: 6 16 ?

Analog
Input sensitivity/Input impedance: 200 mV/47 k?
Frequency response: 10 Hz 100 kHz +1, 3 dB


Following are the specifications for JBL:
SCS 138 Satellite
Frequency Response (-6dB):120Hz 20kHz
Sensitivity (2.83V/1m):86dB
Nominal Impedance:4 Ohms
Recommended Amplifier Power: 10 50 Watts RMS per Channel

SCS 138 Center
Frequency Response (-6dB):120Hz 20kHz
Sensitivity (2.83V/1m):88dB
Nominal Impedance:4 Ohms
Recommended Amplifier Power:10 50 Watts RMS per Channel

SCS 138 Active Subwoofer
Low Frequency Cut-off:35Hz
High Frequency Cut-off:40 Hz - 160Hz Variable
Built-in Power Amplifier:100 Watts RMS

SCS138 System
Frequency Response (-6dB):
35Hz 20kHz