How do I permanently let my receiver that I have small speakers and not large speaker

[arnprasad]

Hi..I have a 1020K...and have two Polk Audio Rti4 speakers, a center speaker and a sub connected to it.

When I run the MCACC - it recognizes my speakers as large....guess this means even the bass frequencies to the speaker and not to my sub..So i go to speaker set up and manually set them up as small...and i have noticed that my sub gets signals now.

however when I do this..there is no save button and when I power off and on my pioneer..it again goes back to "large" speaker status and no signals to sub.

Since there is no save button..what do I do to permanently have the pioneer recognize that I have small speakers and a sub please?

Thanks

 

[ShaQ.Blogs]

Re: How do I permanently let my receiver that I have small speakers and not large spe

When I run the MCACC - it recognizes my speakers as large....guess this means even the bass frequencies to the speaker and not to my sub..So i go to speaker set up and manually set them up as small...and i have noticed that my sub gets signals now.

you will have one more option. Sub setup. Set this to 'sub + main'. This will allow speakers + sub to play. Didnt you do this while setting up MCACC, room correction if I am right runs for both sub & speakers. Was the sub on while you ran MCACC?