Gijo George
Active Member
I had bought the 12 Peerless driver and 150W plate amp as part of the group buy organized by George and T Antony last year. Been putting away the build for a while now but decided its now or never.
The enclosure plans were provided by Antony here http://www.hifivision.com/diy/22681-diy-sub-using-peerless-driver-available-locally-2.html.
A few queries before I start off.
1. TJ's plan doesn't have braces. But I intend to provide two square braces in 3/4" mdf 16.5" x 16.5" with a 32cms dia cut out at the center. (Same dia as the cut out in the front outer baffle.) The braces would be placed parallel in equal distance between the front and back panel. The depth of the enclosure would be increased by 1" to make up the loss in internal volume. Would this work fine?
2. The above braces which I plan to place at about 6" & 12" from the driver, won't allow for the port to be placed on the front (the port's 12" long) Can I place the port on the rear panel such that the the inside end falls anywhere within the 32cms dia of the brace?
So heres the cut list I've prepared. Material planned MDF
1. Front & Back (Outer) 18 x 18 = 2
2. Front & Back (Inner) 16.5 x 16.5 = 2
3. Braces 16.5 x 16.5 = 2
4. Sides 16.5 x 19 = 2
5. Top and Bottom 18" x 19" = 2
Would really appreciate any inputs on the above.
Thanks
The enclosure plans were provided by Antony here http://www.hifivision.com/diy/22681-diy-sub-using-peerless-driver-available-locally-2.html.
A few queries before I start off.
1. TJ's plan doesn't have braces. But I intend to provide two square braces in 3/4" mdf 16.5" x 16.5" with a 32cms dia cut out at the center. (Same dia as the cut out in the front outer baffle.) The braces would be placed parallel in equal distance between the front and back panel. The depth of the enclosure would be increased by 1" to make up the loss in internal volume. Would this work fine?
2. The above braces which I plan to place at about 6" & 12" from the driver, won't allow for the port to be placed on the front (the port's 12" long) Can I place the port on the rear panel such that the the inside end falls anywhere within the 32cms dia of the brace?
So heres the cut list I've prepared. Material planned MDF
1. Front & Back (Outer) 18 x 18 = 2
2. Front & Back (Inner) 16.5 x 16.5 = 2
3. Braces 16.5 x 16.5 = 2
4. Sides 16.5 x 19 = 2
5. Top and Bottom 18" x 19" = 2
Would really appreciate any inputs on the above.
Thanks