I am not denying that you may experience sound difference with speakers cables. I have heard them. To move forward with this topic, let's consider what factors could make cables to sound difference.
Firstly, I may not hearing any difference because I use the correct wire size for the current/voltage requirement of the speakers at the loudest volume I listen to. Secondly, my amplifier is stable right down to 2ohm at 1000W. Thirdly, my speakers cables are rather short. Maybe, less than 8 feet. ( Well.. it came factory terminated. But then audiophiles advised to use bare wire connection. So I cut of the banana plugs off and use them bare with monthly trimming by 1 inch or so to remove the corroded copper. I think it shrunk by more than 1 foot until I soldered back some ordinary banana plugs.) Finally, differences mean they must be distinguishable at all times. I do not want to tell some very minor differences that will be audible when I use one particular track at a particular spot.
Please take part in the poll so that we can be more certain how to improve sound with cables. Your names will not be shown so you can freely express yourself with confidence.
a) I hear difference in cables . Amplifier power rating below150W
b) I hear difference in cables. Speakers cable length more than 8 feet.
c) I hear difference in cables. Loudspeakers measured minimum impedance below 4 ohm. Check manufacturer graph and not specification. If not given it is most likely below 4 ohm.
d) I hear difference in cables. But none of the above.
e) Too small to positively identify the difference with all the sound tracks especially with new unknown tracks.
Firstly, I may not hearing any difference because I use the correct wire size for the current/voltage requirement of the speakers at the loudest volume I listen to. Secondly, my amplifier is stable right down to 2ohm at 1000W. Thirdly, my speakers cables are rather short. Maybe, less than 8 feet. ( Well.. it came factory terminated. But then audiophiles advised to use bare wire connection. So I cut of the banana plugs off and use them bare with monthly trimming by 1 inch or so to remove the corroded copper. I think it shrunk by more than 1 foot until I soldered back some ordinary banana plugs.) Finally, differences mean they must be distinguishable at all times. I do not want to tell some very minor differences that will be audible when I use one particular track at a particular spot.
Please take part in the poll so that we can be more certain how to improve sound with cables. Your names will not be shown so you can freely express yourself with confidence.
a) I hear difference in cables . Amplifier power rating below150W
b) I hear difference in cables. Speakers cable length more than 8 feet.
c) I hear difference in cables. Loudspeakers measured minimum impedance below 4 ohm. Check manufacturer graph and not specification. If not given it is most likely below 4 ohm.
d) I hear difference in cables. But none of the above.
e) Too small to positively identify the difference with all the sound tracks especially with new unknown tracks.
Last edited: