sachu888
Well-Known Member
Hi Bibin,
excellent work:clapping:,Can you share some details on enclosure cost(acrylic?)
Regards,
Sachin
excellent work:clapping:,Can you share some details on enclosure cost(acrylic?)
Regards,
Sachin
Lovely Work!!! Lots of it...Did you get the feet also made in acrylic..not able to make out...The black looks really good...Did you get the lettering also done by the same vendor?? I probably need to consolidate all my requirements and make a trip to Kochi....
Hi Bibin,
excellent work:clapping:,Can you share some details on enclosure cost(acrylic?)
Regards,
Sachin
Awesome work bibin! pls share the details of the build & components used
:clapping:
Very nice enclosure Bibin. Finish is top notch. Thanks for sharing.
What plans so you have for the active Xover?
Sent from my iPhone using Tapatalk
The Active X-over is a 3 way one, please see the following link for more details.
Silicon Chip Online - Active 3-Way Crossover for Loud Speaker Systems
I have build one prototype of that, but there is some issue with the low section. Mid and High are awesome when played through Class A Hiraga amp. Need to troubleshoot the issue with low section.
Bibin, How much do they charge for powder coating? Have you seen the finish?Yes the feet are also made from 15mm clear acrylic. Lettering are done at the same place. Actually it is laser engraving on acrylic and filled with some acrylic/fabric paint.
There is another place here dealing with sheet metal works. Last weekend i had visited their place to see some sample works. They have all the machinery for bending, powder coating, anodizing, vent cutting etc. I will visit them after two weeks to order few cabinets for amplifiers and active X-over. They also do the lettering on metal using Lith printing.
Thanks bibin, which Jean Hiraga Amp do you own?
Bibin, How much do they charge for powder coating? Have you seen the finish?
Bangalore folks should check this out - it should make
some nice front panels for your next DIY cabinet -
LASER MARKING ON METAL - Bangalore - Other Services - laser cnc cutting
very impressed,Yes the feet are also made from 15mm clear acrylic. Lettering are done at the same place. Actually it is laser engraving on acrylic and filled with some acrylic/fabric paint.
There is another place here dealing with sheet metal works. Last weekend i had visited their place to see some sample works. They have all the machinery for bending, powder coating, anodizing, vent cutting etc. I will visit them after two weeks to order few cabinets for amplifiers and active X-over. They also do the lettering on metal using Lith printing.