Hi,
As my amp project progresses slowly I come across niggling problems that I need solutions to.
The ready cabinet that I purchased at Lamington road has prepunched holes for the control pots
Since the preamp board I'm making had pots soldered on the board that don't match the holes on the cabinet, I've had to connect the pots via wires to mount on the panel
But the movement of the boards for testing keeps breaking the wires at the PCB level
Is there any recommendation for sturdy wires that won't break so easily
Or techniques to reinforce the wires to prevent breakage
Regards
As my amp project progresses slowly I come across niggling problems that I need solutions to.
The ready cabinet that I purchased at Lamington road has prepunched holes for the control pots
Since the preamp board I'm making had pots soldered on the board that don't match the holes on the cabinet, I've had to connect the pots via wires to mount on the panel
But the movement of the boards for testing keeps breaking the wires at the PCB level
Is there any recommendation for sturdy wires that won't break so easily
Or techniques to reinforce the wires to prevent breakage
Regards