Not related with the crossover but are you trying for a EBS alignment with this? If yes, why? Don't you intend using a sub?My enclosure volume is 11.7 liter and ported tuning frequency is ~50Hz.
I used only a 10uf BP capacitor to feed the tweeter above 2500Hz.
If you want I can provide you coil winding details for that 0.3mH & 0.6mH inductors.
looking at the tweeter graph, 4k looks like a good point.. no graph for the woofer, can you post one.
IMO, acc. to the TS parameters given on the DIYAudioCart site, that driver likes a ~16litre box tuned to ~69Hz.
IMO, acc. to the TS parameters given on the DIYAudioCart site, that driver likes a ~16litre box tuned to ~69Hz.
But believe me, that is not sounding good. It is wobbling like anything.
Don't use a single pass capacitor arrangement for the tweeters. That's a 6db/octave approach. Tweeter will not sound clean.
Follow this schematics. You shall get towards your goal.It's an asymmetrical arrangement ...... 6dB/octave for your LF/MID & 12dB/octave for HF, crosses at 3kHz.
The lamp is 12V/35W low resistance lamp (> 0.5ohms). It works as a limiter. Is a must for small sized drivers.
If you want I can provide you coil winding details for that 0.3mH & 0.6mH inductors.