Hi,
I am unable to do a firmware update or even Check the existing Firmware version.
The following procedures are not working for me. (Instructions given in RXA800_Firmware_Update_Ver_2.05 pdf)
I did the following as instructed:
1 Put Amp into standby mode by pressing the power button.
2 Whilst it's in standby pressed the straight button, and then without letting go of the straight button pressed the power button.
3 Now I am able to see the Advanced Menu option for a few seconds on the screen of the Amp which changes to SP Imp change option almost immediately
4 Releasing the straight button immediately after getting advanced Menu option and holding the Tone button for more then 3 secs does not show the firmware version nor does holding the Info button for 3 secs give me CDDA Upgrader option .
In both cases the AVR goes into Speaker Impedence Change menu option and SP Imp 8 Ohms Min is displayed
Any one who did the Firmware update ? Please help
Thanks
I am unable to do a firmware update or even Check the existing Firmware version.
The following procedures are not working for me. (Instructions given in RXA800_Firmware_Update_Ver_2.05 pdf)
I did the following as instructed:
1 Put Amp into standby mode by pressing the power button.
2 Whilst it's in standby pressed the straight button, and then without letting go of the straight button pressed the power button.
3 Now I am able to see the Advanced Menu option for a few seconds on the screen of the Amp which changes to SP Imp change option almost immediately
4 Releasing the straight button immediately after getting advanced Menu option and holding the Tone button for more then 3 secs does not show the firmware version nor does holding the Info button for 3 secs give me CDDA Upgrader option .
In both cases the AVR goes into Speaker Impedence Change menu option and SP Imp 8 Ohms Min is displayed
Any one who did the Firmware update ? Please help
Thanks