I made some progress with the cabinets.
https://picasaweb.google.com/107361765185238952016/September212012?authkey=Gv1sRgCI2uoL_qr7_reg
https://picasaweb.google.com/107361765185238952016/September212012?authkey=Gv1sRgCI2uoL_qr7_reg
I made some progress with the cabinets.
https://picasaweb.google.com/107361765185238952016/September212012?authkey=Gv1sRgCI2uoL_qr7_reg
great build... r u doing it personally..or with the help of a carpenter...
Hi Guys
I am in the process of putting the No rez on side walls and realised I ordered only 1 sheet and it is not sufficient to put on all 3 walls (2 sides and back) for my X-Ls Encore Floor standers. Can anyone recommend some alternative which can go along with No Rez. Do we need to tightly pack all the three walls with No Rez leaving the braces or leaving gaps would be alright?
Can anyone recommend some alternative which can go along with No Rez. Do we need to tightly pack all the three walls with No Rez leaving the braces or leaving gaps would be alright?
No Rez in a combination of bitumen sheet for damping and spongy material for absorbing the standing waves. For proper effect, the entire cabinet must be covered with No Rez. If you do not have sufficient quantity, a combination of Bitumen sheets and firm sponge/Glasswool/Recron (did I spell it right?) can be used IMO.
Thanks Captain, I am too short of No Rez since I went for the Floor stander. I'll cover the top part completely with No Rez for both the speakers and towards the bottom, for the remaining area, I'll use bitumen sheets with Glasswool/sponge etc.
While doing my first build of the N2X even I fell short of the NoRez. I wrote to Danny and this is what he replied.
N2X Build
Not sure what you are asking, see the link which i had given in post 21. The pictures of my build is available there including the front baffles.Hey guys, could you please post a snaps of the front baffle of the speakers showing the radius that Danny had mentioned on the inner side of the woofer hole? It would really help.
.....
Thanks!
Not sure what you are asking, see the link which i had given in post 21. The pictures of my build is available there including the front baffles.
Welcome to AC.
One thing I noticed is that the through hole for the woofer lacks a radius on the back side. This is actually very crucial. If not done then it negatively effects the woofers response. And if the front baffle gets thicker then the radius on the back side needs to increase as well.
I made note of it now in Red on the cabinet plans. http://gr-research.com/pdf/X-LS Encore box.pdf