Have purchased Denon x3600H recently. Previously owned onkyo AVRs.
With Denon x3600H , Observed the sound comes alive only when the volume is >50 db . < 50 db the volume is very less and could not hear the sound.
I have ran audyssy too and tried. Tried all possible settings , turning off EQ , on , Audyssy on and off etc , Echo mode etc..
The volume is same.
With onkyo AVR the sound comes alive with min 30 to 35 db , and when i turn up volume more than 50 db it plays very loud.
But with Denon min volume 50 db , and after >85 db it plays loud.
Note : I have tried with same source of input & modes ..etc with both AVRs.
Sound quality is good with Denon AVR, so i dont think any issue with my Denon AVR , Only the volume control is different from Onkyo.
Is this by design ?
Thanks in advance for your inputs.
With Denon x3600H , Observed the sound comes alive only when the volume is >50 db . < 50 db the volume is very less and could not hear the sound.
I have ran audyssy too and tried. Tried all possible settings , turning off EQ , on , Audyssy on and off etc , Echo mode etc..
The volume is same.
With onkyo AVR the sound comes alive with min 30 to 35 db , and when i turn up volume more than 50 db it plays very loud.
But with Denon min volume 50 db , and after >85 db it plays loud.
Note : I have tried with same source of input & modes ..etc with both AVRs.
Sound quality is good with Denon AVR, so i dont think any issue with my Denon AVR , Only the volume control is different from Onkyo.
Is this by design ?
Thanks in advance for your inputs.