Driver selection for Center and surround back speaker

[swpnit]

Hi,

Please help me to choose correct driver selection for center speaker and rear surround

Also help me what will correct crossover point in each case.

For woofer
------------------------------------
Peerless SKO130

Peerless - 5.25" High fidelity 8 Ohm woofer - SKO130

or

Peerless KO100

Peerless - 4" Coated Paper Cone Woofer - KO100

For Tweeter
---------------------
Peerless LR10DT

Peerless - 25mm Fabric Dome Tweeter - LR10DT

or

Peerless SR10DT

Peerless - 25mm Fabric Dome Tweeter - SR10DT.


My AVR is Yamaha RX V371 US model.

Front speaker is sonodyne sx 606.

Sub will added after few day using peerless 10 inch driver.

Please answer me asap

Thanks,
Swarup

 

[swpnit]

Finally i choose these for center and surround back
Peerless KO100
Peerless - 4" Coated Paper Cone Woofer - KO100
Peerless LR10DT
Peerless - 25mm Fabric Dome Tweeter - LR10DT
is it ok.

1st order crossover for surround back and center.

what will be crossover point.


As well as i want to modify my existing sonodyne speaker.

please give me some idea about easy available damping material and how it will applied into cabinet.

Thanks,please help me asap.

 

[soundnovice]

i would prefer m13nh (5.25") over sko130 or KO100. also see if you can go for sr10dt. it has bigger magnet and has better performance than LR10dt. since its for rear and center, i really dont see any point to cover lower bass below 80hz. you can even go for 3"/4" full range drivers, may be two per channel.

 

[swpnit]

actually my avr take only 8 ohms load and
my front speaker from sonodyne has 8 ohms load.

m13nh i think 4 ohms load how i can manage.

what will be my crossover 1st/2nd/3rd or 4 th.

i am very novice here but i want to learn as i love sound.

yes i am also thinking of SR10DT it is very good driver.

but for woofer/crossover i was confused.

Please help me on this.