waris
Active Member
A very good morning to all FMs.
I have been taking guidance from all of you and managed to setup my 5.1.2 system . I have following configuration.
Denon x2400h
HTS12
Q acoustics 3020i + 3090c
Polk S10 in side surrounds
Polk OWM3 in Top middle
I have a TOX1 with coreelac set to pass through to AVR.I get good surround effects but almost no ATMOS effect. I have tried many movies including Dune (has many overhead scenes).
I have completed Audyssey Calibration. OWM3 are hanging from ceiling in the dolby suggested location.
What am I missing? Any pointers are welcome.
Here is a pic ofATMOS SPEAKERS LOCATION from an earlier thread.
In this pic you can see placement of ssurround w.r.t room.
Room dimensions are 15 x12 ft. I am sitting at 10ft from TV. From back wall my distance is 1ft as sofa is attached to the wall. However I sometimes pull it ahead.
From MLP Top left is at 1ft more distance compared to Top Right.
I have been taking guidance from all of you and managed to setup my 5.1.2 system . I have following configuration.
Denon x2400h
HTS12
Q acoustics 3020i + 3090c
Polk S10 in side surrounds
Polk OWM3 in Top middle
I have a TOX1 with coreelac set to pass through to AVR.I get good surround effects but almost no ATMOS effect. I have tried many movies including Dune (has many overhead scenes).
I have completed Audyssey Calibration. OWM3 are hanging from ceiling in the dolby suggested location.
What am I missing? Any pointers are welcome.
Here is a pic ofATMOS SPEAKERS LOCATION from an earlier thread.
In this pic you can see placement of ssurround w.r.t room.
Room dimensions are 15 x12 ft. I am sitting at 10ft from TV. From back wall my distance is 1ft as sofa is attached to the wall. However I sometimes pull it ahead.
From MLP Top left is at 1ft more distance compared to Top Right.