lightpower
New Member
I couldn't find a relevant thread on this hence starting a new one.
I own a Yamaha RX-V679 receiver ( Bought from UK )and it was prompting for a Firmware update since 1st April. I decided to bite the bullet yesterday and went ahead in updating the firmware through Network. THe update took around 40 mins and was successful. After the update I powered down the using using the Main Zone button.
After that there is no standby light and the unit is dead. Its not powering ON, No display and not hearing any relay clicks as well. Tried to do a USB Update using the procedure mentioned in the "Troubleshooting section" of the firmware update manual but of no use, still the unit is to responding.
Any suggestions/help here ?
I own a Yamaha RX-V679 receiver ( Bought from UK )and it was prompting for a Firmware update since 1st April. I decided to bite the bullet yesterday and went ahead in updating the firmware through Network. THe update took around 40 mins and was successful. After the update I powered down the using using the Main Zone button.
After that there is no standby light and the unit is dead. Its not powering ON, No display and not hearing any relay clicks as well. Tried to do a USB Update using the procedure mentioned in the "Troubleshooting section" of the firmware update manual but of no use, still the unit is to responding.
Any suggestions/help here ?