After failing to find a good AV rack at reasonably price, I decided a custom design
from Extruded Aluminium would be better. I had seen it used for factory racks.
It worked out relatively cheap for its size and offers the flexibility of moving the Racks Up and Down with an Alan Key to accommodate different height components.
Thought I would share it in case someone else is also looking for something similar.
This was designed for me by Mr.Sriram of Kamal & Co in T.Nagar. I Just gave the dimensions for the equipment and they designed and got it fabricated. The entire setup is in aluminium and has
acrylic sheets for the base. Since the fabrication was outsourced it was about 24k for labour and all the material.
I bet it would have been lot cheaper if I had the skill and got the extrusions and binders and cut and assembled it myself.
I tagged two wire organizers on either sides of the rack, one for power and one for signal to cleanup the wire clutter.
from Extruded Aluminium would be better. I had seen it used for factory racks.
It worked out relatively cheap for its size and offers the flexibility of moving the Racks Up and Down with an Alan Key to accommodate different height components.
Thought I would share it in case someone else is also looking for something similar.
This was designed for me by Mr.Sriram of Kamal & Co in T.Nagar. I Just gave the dimensions for the equipment and they designed and got it fabricated. The entire setup is in aluminium and has
acrylic sheets for the base. Since the fabrication was outsourced it was about 24k for labour and all the material.
I bet it would have been lot cheaper if I had the skill and got the extrusions and binders and cut and assembled it myself.
I tagged two wire organizers on either sides of the rack, one for power and one for signal to cleanup the wire clutter.