Hi all - just got a brand new Denon PMA-60 from Japan and of course, the damn thing wont start.
It powers up, the logo flashes and then immediately, it goes into "circuit protection" mode, with a red LED flashing every 0.5 seconds - which, going by the manual, is either a case of speaker wires shortcircuiting or an amplifier section failure. Since i dont have any cables plugged in, it is an amp failure.
Anyone know of a Denon service center or any other qualified service center which might be able to fix this?
(And yes, I am using a 220-240 -> 100W voltage adapter, rated to 100W vs the amp's 35W requirement).
It powers up, the logo flashes and then immediately, it goes into "circuit protection" mode, with a red LED flashing every 0.5 seconds - which, going by the manual, is either a case of speaker wires shortcircuiting or an amplifier section failure. Since i dont have any cables plugged in, it is an amp failure.
Anyone know of a Denon service center or any other qualified service center which might be able to fix this?
(And yes, I am using a 220-240 -> 100W voltage adapter, rated to 100W vs the amp's 35W requirement).